User Manual

42
7
DSC OPERATION
■ Making DSC calls
D Making a Position Report call (continued)
r Push [CALL] to make a Position Report Call.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
t After the Position Report Call has been transmitted, the
transceiver automatically returns to the normal operating
mode.
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both position
and time have been manually entered, the screen as shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
*For only IC-M423G and IC-M424G.
➥ Push [CHG], then edit your latitude and longitude position
and UTC time.
• Select a desired number using Dial, or [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENT] or Dial.
• Select N (North latitude) or S (South latitude) when the cursor
is on the ‘N’ or ‘S’ position.
• Select W (West longitude) or E (East longitude) when the cur-
sor is on the ‘W’ or ‘E’ position.