User Manual

33
7
DSC OPERATION
New2001
Transmitting a Group call D
The Group call function allows you to transmit a DSC signal
to only a specific group.
Enter “GROUP CALL” in the DSC CALLS menu. q
MENU ➪ DSC ➪ Group Call
(Push [MENU]) (Select icon) (Rotate dial, then push [ENT].)
Select the desired pre-programmed group address or w
“Manual Input,” using dial or [Y]/[Z], then push [ENT].
 •TheIDcodefortheGroupcallcanbesetrst.(p.20)
 •When“ManualInput”isselected,setthe8digitIDcodeforthe
group you wish to call.
e Select a desired intership channel using dial or [Y](CH)/
[Z](CH), then push [ENT].
 •Intershipchannelsarealreadypresetintothetransceiverinthe
recommended order.
About Manual Inputting:
Enter a desired group ID in the following way:
•Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
•Push[ENT]ordialtosetit.
•Tomovethecursor,rotatedialor select either arrow, “←” or “→,”
then push [ENT] or dial.
•Therstdigitisspeciedas‘0’foraGroupID.
•Thersttwodigitsare‘0’foranyCoaststationID.