User Manual

40
7
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Push [CALL] to transmit the Position Report Call. r
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechannel
becomes clear.
After the Position Report Call has been transmitted, the t
transceiver automatically returns to the normal operating
mode.
When no GPS receiver is connected, and both position and
time have been manually programmed, the screen shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
Push [CHG], then edit your latitude and longitude position ➥
and UTC time.
 •Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]ordialtosetit.
 •To move the cursor,rotate dial or select either arrow,“←” or
“→,” then push [ENT] or dial.
 •SelectN(Northlatitude)orS(Southlatitude)whenthecursor
is on the ‘N’ or ‘S’ position.
 •SelectW(Westlongitude)orE(Eastlongitude)whenthecur-
sor is on the ‘W’ or ‘E’ position.