Operation Manual

43
11
SET MODE
11
■ Initial set mode
Initial set mode operation is used for programming in-
frequently changed values, conditions or functions.
DD
Entering set mode
q Turn the power OFF, if the transceiver is powered
ON.
w While pushing [MODE SET ], push [POWER] to turn
the power ON to enter initial set mode.
e Rotate [GRP] to select the desired item.
r Rotate [CH] to set the values or conditions for the
selected item.
t Turn the power OFF and ON again to exit set mode.
DD
Initial set mode items
NOTE: Selection of some of the set mode items de-
scribed here are not available on some transceiver
versions.
[POWER][MODE SET]
Number of user channels
This item sets the number of user channels. Up to
160 channels can be set. (default: 160)
*** SET MODE ***
ITEM SEL
FSK ITU channel selection
This item sets the capability of the ITU channels for
FSK from ON and OFF.
This item will not appear when ITU channels are in-
hibited. (default: ON)
*** SET MODE ***
ITEM SEL
OFF
ON
ÇÇ
Automatic tune
When an optional automatic antenna tuner is con-
nected, tuning can be started automatically without
pushing [TUNE
THRU ], for instant operation.
If manual tuning is required, this automatic operation
can be deactivated.
(default: OFF)
*** SET MODE ***
OFF
ON
ÇÇ
ITEM SEL
Scan type
This item selects one of the following scan functions.
Programmed scan searches signals within the fre-
quency range and activates slowly while squelch is
open and fast while squelch is closed.
Channel scan and channel resume scan searches 20
channels around a user selected channel, or
searches all ITU channels in the band when an ITU
channel is selected. (default: CH SCAN)
*** SET MODE ***
CH
SCAN
CH-RESUME
SCAN
PROGRAM
SCAN
ÇÇ
ITEM SEL
IC-M801E_0.qxd 05.12.2 16:32 Page 43