User Guide
5
13
CHANNEL NAME PROGRAMMING
2001 NEW
4
5
D Programming
q Select the desired channel to be programmed.
w Push [FREQ/CH] to select channel indication
mode, if desired.
e Push [F] then [FREQ/CH].
• The 1st character for the channel names blinks.
r Rotate [CH] selector to select the character for
channel names.
• See the table below for available characters.
t Push the keypad several times to enter that char-
acter.
y Repeat steps r and t to enter the channel name.
u Push [ENT] for 1 sec. to program the channel
name.
CH
---GPS---
Lat
45
59'N
Lon134
44'E
16:23
RX J3E
DUP
0
1
2
3
4A
CH
---GPS---
Lat
45
59'N
Lon134
44'E
16:23
RX J3E
DUP
0
1
2
3
4A
CH
---GPS---
Lat
45
59'N
Lon134
44'E
16:23
RX J3E
DUP
0
1
2
3
4A
Up to 8-character channel names can be assigned for
each user and ITU channel. This may be helpful for in-
dicating the frequency usage, ship name, etc.
NOTE: The display type must be set to “CH-
NAME” to display/program the channel names in ini-
tial set mode. (p. 44).
• Available characters
(space)
KEY CHARACTERS KEY CHARACTERS
IC-M801E_0.qxd 05.12.2 16:32 Page 13