User Guide

6
14
DSC PREPARATION
2001 NEW
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity:
DSC self ID) code can be programmed.
This operation is not available when the MMSI code
has been programmed by your dealer. The code re-
programming cannot be performed. This code is dis-
played during DSC watch mode.
DD
Programming
q The following screen will be displayed briefly at
power ON when no MMSI code is programmed.
w Push [DSC] to select MMSI code programming
condition.
e Enter the specified 9-digit MMSI code via the key-
pad.
• Make sure the correct code is entered.
• Rotate [CH] to move the cursor.
r Push [ENT] to program the code.
• After pushing [ENT], DSC menu is displayed as below.
t Push [MODE SET ] to exit the DSC menu.
******** Set up ********
--------
Select --------
Group
ID
Call
frequency
Traffic
frequency
Scan
frqeuency
Number
MMSI
check
Ç
OKSEL
******** Set up ********
---------
MMSI ---------
ID:123456789
OK
******** Set up ********
---------
MMSI ---------
ID:
† ________
OK
<MMSI>
No
MMSI !
[MODE SET][ENT]
[DSC]
IC-M801E_0.qxd 05.12.2 16:32 Page 14