User Guide

41
10
DSC MENU OPERATION
10
■ Memory reading/deleting
q During setup select menu indication, rotate [CH] to
select the desired memory item then push [ENT].
• Push [DSC] to select DSC watch mode.
• Push [MODE
SET ] to select DSC menu.
• Rotate [CH] to select “Set up” then push [ENT].
w Rotate [CH] to select the desired memory, then
push [ENT].
e Operate as follows:
➥ When reading the memory contents only;
•Push [ENT] to return to the appropriate mem-
ory list screen.
➥ When deleting the memory contents;
• Push and hold [CE] for 1 sec.
-After deleting, the appropriate memory list screen
is displayed automatically.
******** Set up ********
********
Set up ********
--
Traffic frequency ---
----
Call frequency ----
********
Set up ********
----
Scan frequency ----
DEL
OK
Comment:ICOM Group
TX:
4567.0kHz
RX:
4567.0kHz
******** Set up ********
------
Address ID ------
********
Set up ********
-------
Group ID -------
DEL OK
Name:ICOM M801
ID:012345678
TX:
2345.0kHz
RX:
2345.0kHz
■ Printing out the DSC memory contents
The received DSC call contents can be printed out
when a printer (IBM
®
centronics or compatible) is con-
nected to the transceiver.
The automatic print out capability when a DSC call is
received is available in initial set mode. (p. 46)
q Select the desired received DSC memory as de-
scribed in “Received information” (p. 30).
➥ During DSC watch mode, push [RX CLAR ] to
enter the received DSC memory select screen.
•Or, push [MODE SET ], rotate [CH] to select “RX
memory” then push [ENT].
➥ Rotate [CH] to select the desired category from
“Distress” and “Others” then push
[ENT].
•“<No data>” is displayed beside category when
no received message is stored in the category.
➥ Rotate [CH] to select the desired DSC message.
•“*” means the DSC messages have not been read.
•“DTRS RLY” stands for distress relay.
w Push [ENT] to indicate the contents.
e After pushing [F], push [8 PRN ] for 1 sec. to print
out the selected DSC memory contents.
[8 PRN]
[F]
IC-M801E_0.qxd 05.12.2 16:32 Page 41