User Guide

102
10
BAND SCOPE (Multi-function receiver/Component screens only)
The frequency steps used while sweeping are automatically
set according to the tuning step. However, these steps can
be defined using the [Scope (FREQ)] setting screen on the
setting screen.
qRight-click the zFREQx button to call up the [Scope
(FREQ)] setting screen if it is not displayed.
wClick the desired frequency step range in the [Automatic
Sweep Step Limit].
• The sweep step range can be selected from one of 1–100 kHz,
1–50 kHz or 1–25 kHz.
eClick the close ([X]) button to close the setting screen.
METER/SCAN
Active band only
Active band only
• [Compo] screen
• [Receiver] screen
IC-PCR2500IC-PCR1500
IC-PCR2500IC-PCR1500
zFREQx
Right click
zFREQx
Right click
Click to the desired
sweep step.
• [Scope (FREQ)] screen
■ Changing the automatic sweep step limit