User Guide

SCAN OPERATION

Scan edges can be programmed in the same manner as

memory channels. Scan edges are programmed into scan

edges, 0A/0B to 49A/49B, in memory channels.

q Push the desired band’s [VFO/MR•S.MW] once or twice

to select VFO mode

w Set the edge frequency of the desired frequency range:

➥ Set the frequency using the same band’s [DIAL].

➥ Set other data (e.g. tone squelch, etc.), if desired.

e Push and hold the same band’s [VFO/MR•S.MW] for

1 sec. to enter select memory write mode

•“!” indicator and the memory channel number blink.

r Rotate the same band’s [DIAL] to select one of scan edge

channel, 0A to 49A.

t Push and hold [VFO/MR•S.MW] for 1 sec. to program.

•3 beeps sound and VFO mode is automatically selected.

•Scan edge 0B to 49B is automatically selected when continuing

to hold [VFO/MR•S.MW] after programming.

y To program a frequency for the other pair of scan edges,

0B to 49B, repeat steps w to r.

• If the same frequency is programmed into a pair of scan edges,

programmed scan will not function.

[EXAMPLE]: Programming 144.000 MHz into scan edge 1A.

Push Rotate for setting frequency, etc. Push for 1 sec.

Rotate Push for 1 sec. and continue to push

➠

Beep

S.MW

VFO/MR

S.MW

VFO/MR

S.MW

VFO/MR

Release

S.MW

VFO/MR

■ Scan edges programming