User Guide
22
7
DTMF MEMORY
■ Programming a DTMF code
The transceiver has 5 DTMF memory channels (d1 to d5) for
storage of often-used DTMF codes of up to 32 digits.
➀ Push [
f
(DTMF)] to enter DTMF
memory.
• One of “d1” to “d5” appears.
➁ Push [Y]/[Z] to select the desired
channel.
➂ Push [
f
(DTMF)] for 1 sec. to enter
DTMF programming mode.
•“_____” appears.
• Programmed memories can be
cleared in this way.
➃ Push the digit keys to enter the desired DTMF code.
• A maximum of 32 digits can be input.
• If a digit is mistakenly input, push [ ] then repeat from step ➀.
➄ Push [
f
(DTMF)] to input the
digits and exit DTMF programming mode.
• A beep sounds.
■ Transmitting a DTMF code
D Using a DTMF memory channel
➀ Push [
f
(DTMF)] to enter DTMF memory mode.
➁ Push [Y]/[Z] to select a DTMF memory channel to trans-
mit.
➂ Push [
f
(DTMF)] to transmit the displayed DTMF memory.
• After the DTMF code is transmitted, the transceiver automatically
returns to normal operating mode.
D Manual DTMF code transmission
➀ While pushing [PTT], push digit keys to transmit a DTMF
code manually.
➁ Release [PTT] to return to receive.
✔ CONVENIENT
DTMF re-dial function: This function automatically re-trans-
mits the previously sent DTMF code. This is especially con-
venient when you want to re-transmit a manually transmitted
DTMF code.
Push [
f
(RE-DIAL)] to activate the function. See p. 31 to as-
sign this function to a switch, if necessary.
NOTE: Once the transceiver is turned off, any temporarily
memorized DTMF contents will be cleared.
IC-T2H_RTTE.qxd 03.6.20 18:58 Page 22 (1,1)