User Guide
25
8
SCAN OPERATION
■ Programmed scan
Programmed scan repeatedly scans between two user-pro-
grammed frequencies (memory channels “PA” and “Pb”). This
scan is useful for checking for signals within a specific fre-
quency range such as repeater output frequencies, etc.
➀ Push [A V] to select VFO mode, if necessary.
➁ Push [SC] to start the scan.
• To change the scan direction, push [Y] or [Z].
➂ Push [SC] again to stop the scan.
NOTE: Scan edges, PA/Pb, must be programmed in ad-
vance (program them in the same manner as regular
memory channels—p. 19).
If the same frequencies are programmed into the scan
edges, programmed scan will not proceed.
■ Memory (skip) scan
Memory scan repeatedly scans all programmed memory
channels, except those set as skip channels.
➀ Push [A V] to select memory mode, if necessary.
•“X” appears.
➁ Push [SC] to start the scan.
• To change the scan direction, push [Y] or [Z].
➂ Push [SC] again to stop the scan.
D Setting skip channels
In order to speed up the scan interval, you can set memory
channels you don’t wish to scan as skip channels.
➀ Push [A V] to select memory mode, if necessary.
•“X” appears.
➁ Push [Y]/[Z] to select a memory channel to set as a skip
channel.
➂ Push [SC] for 1 sec. to toggle the
skip setting on/off.
•“SKIP” appears when the channels is
set as a skip channel.
• If memory scan is accidentally started,
push [SC] to stop it.
MR
SKIP
Memory channel 10 is
set as a skip channel.
IC-T2H_RTTE.qxd 03.6.20 18:58 Page 25 (1,1)