User Guide

35
11
ANI OPERATION
D Calling group stations
➀ Turn power on, then select the desired group channel.
➁ Enter the 3-digit ANI code including the group code “D”—
the transceiver calls the desired station automatically.
• The transceiver transmits the pre-programmed selective code.
• When entering a 3-digit code, the transceiver automatically trans-
mits a group code after the 3rd digit is entered.
• When making group calls the transceiver does not ring and no
answer back connection code is received.
• You can make an announcement to your group immediately with-
out a connection procedure.
➂ Push [PTT] in the regular way to communicate.
➃ When your conversation is finished, while pushing [PTT],
push [#] to transmit a disconnect code.
D Group call code examples
[Example 1]
If “11D” is transmitted, transceivers with receive codes “110”
to “119” are called.
[Example 2]
If “1D3” is transmitted, transceivers with receive codes “103,”
“113,”…“183” and “193” are called.
NOTE: “DDD” transmits to all transceivers.
D Waiting for a call
➀ Turn power on, then select the de-
sired channel.
• The transceiver may be programmed
to start a scan at power on.
➁ When you receive a selective call,
the transceiver “rings.”
• Push [ANI CODE] to display the re-
ceive code.
➂ Push [PTT] to send a connection code within 10 sec.
➃ While “” flashes, converse with the connected station.
➄ When your conversation is finished, you may receive a dis-
connect code.
• Transmitting a disconnect code from your side (push [PTT] + [#])
is also possible (except for group call receive).
• “” stops flashing.
IC-T2H_RTTE.qxd 03.6.20 18:58 Page 35 (1,1)