Instruction Manual

■ Power ON
Push [POWER] for 1sec. to turn
power ON
.
■ Setting a frequency
D Via the keypad
q Push [D. CLR ] to select VFO mode, if necessary.
w Push 6 digit keys, starting from the 100 MHz digit, to enter
the desired frequency.
• When [#• ENT ] is pushed after three or more digits are entered,
also the frequency is set.
• When a digit is mistakenly input, push [D. CLR ] to abort imputing.
• “2” and “7” are acceptable for the 1 kHz digit (depending on the 10
kHz digit).
16
4
BASIC OPERATION
15
3
BATTERY PACKS
‘‘
Battery case (optional for some versions)
When using a BP-208 BATTERY CASE attached to the transceiver,
install 6 AA (R6) size alkaline batteries as illustrated below.
DD
CAUTIONS
• Use ALKALINE batteries only.
• Make sure all battery cells are the same brand, type and ca-
pacity.
• Never mix old and new batteries.
Either of the above may cause a fire hazard or damage the
transceiver. If ignored.
• Never incinerate used battery cells since internal battery gas
may cause them to rupture.
• Never expose a detached battery case to water.
If the battery case gets wet, be sure to wipe it dry before using.
MR
or
MR
Push
Push for 1 sec.