Instruction Manual

24
5
REPEATER OPERATION
23
5
REPEATER OPERATION
■ Auto repeater
function
(USA version only)
The USA version automatically activates the repeater settings (du-
plex, ON/OFF, duplex direction, tone encoder ON/OFF) when the
operating frequency falls within or outside of the general repeater
output frequency range. The offset and repeater tone frequencies
are not changed by the auto repeater function, reset these fre-
quencies, if necessary.
q While pushing [Y]+[Z], turn the power ON to enter INITIAL SET
MODE
.
w Push [Y]/[Z] several times until
“RPt.” appears.
e Rotate [VOL] to select the desired
condition.
• “OF”—the auto repeater function is
turned OFF;
“R1”—the auto repeater function acti-
vates for duplex only;
“R2”—the auto repeater function acti-
vates for duplex and tone.
r Push [#• ENT ] to exit INITIAL SET
MODE
.
USING
INITIAL SET MODE
Frequency range and offset direction
FREQUENCY RANGE DUPLEX DIRECTION
145.200–145.495 MHz
“–” appears
146.610–146.995 MHz
147.000–147.395 MHz “+” appears
SKIP
AO
LM
MR
F
TX
75
50
25
D
SKIP
AO
LM
MR
F
TX
75
50
25
D
SKIP
AO
LM
MR
F
TX
75
50
25
D
✔ Convenient
Tone scan function: When you don’t know the subaudible tone
used for a repeater, the tone scan is convenient for detecting the
tone frequency.
Push [3•
T . SCAN ] after pushing [A• FUNC ] to start the tone scan.
• Push [D• CLR ] to cancel the scan.
• When the wanted tone frequency is detected, the scan pauses.
DD
Tone information
Some repeaters require a tone to be accessed.
DTMF TONES
While pushing [PTT], push the desired DTMF keys (0–9, A–F) to
transmit DTMF tones.
• The transceiver has 5 DTMF memory channels (p. 28).
1750 Hz TONE
While pushing [PTT], push [Y] or [Z] for 1 to 2 sec. to transmits
1750 Hz tone signal.