Instruction Manual

29
7
DTMF MEMORY
30
8
SCAN OPERATION
PROGRAMMED SCAN
MEMORY (SKIP) SCAN
Mch 0
Mch 6
Mch 1 Mch 3
Mch 2 Mch 4 Mch 5
Mch 7
Mch 99 Mch 10 Mch 9 Mch 8
Scan
Scan edges
PRIORITY WATCH
Mch 3
Priority memory channel scan
Priority channel
50 msec.
VFO frequency
145.20 MHz
5 sec.
Mch 3
Mch 5Mch 1
Mch 2 Mch 4
Mch 6
SKIP
Mch 99
50 msec.
Memory
scan
Priority channel
Priority memory channel watch
VFO frequency
145.20 MHz
5 sec.
SKIP
SKIP
Band edge Band edge
Jump
1A
2A
3A
1b
2b
3b
■ Scan types■ Transmitting a DTMF code
D Using a DTMF memory channel
q Push [0• DTMF - M ] after pushing [A• FUNC ] to enter DTMF memory.
w Rotate [VOL] to select the desired channel.
r Push [SQL] or [PTT] to exit DTMF memory mode.
t While pushing [PTT], push [SQL] to transmit the selected DTMF
memory.
• After the DTMF code is transmitted, returns to receive automati-
cally.
D Manual DTMF code transmission
q While pushing [PTT], push digit keys, A–F to transmit a
DTMF code manually.
• Once DTMF code key is pushed, the transmission is kept for 1 sec.
after release the key even [PTT] is released.
■ DTMF
transmission speed
When slow DTMF transmission speeds are required with DTMF
memory transmission (as for some repeaters), the transceiver’s rate
of DTMF transmission can be adjusted.
q While pushing [Y] and [Z], turn the
power on to enter
INITIAL SET MODE .
w Push [Y]/[Z] several times until “dtd”
appears.
e Rotate [VOL] to select the desired
DTMF transmission speed.
• Four speeds are available: “1” (100
msec. intervals) is the fastest; “5” (500
msec. intervals) is the slowest.
r Push [#• ENT ] to exit INITIAL SET MODE .
USING
INITIAL SET MODE
MR
MR