Instruction Manual

32
8
SCAN OPERATION
31
8
SCAN OPERATION
■ Programmed scan
Programmed scan repeatedly scans between two user-pro-
grammed frequencies (memory channels “1A–3A” and “1b–3b”) or
scans between upper and lower band edges. This scan is useful
for checking for signals within a specific frequency range such as
repeater output frequencies, etc.
q Push [D•
CLR ] to select VFO mode, if necessary.
w Push [5•
SCAN ] after pushing [A• FUNC ] to start the scan, then a
selected scan edge appears as “P1”, “P2”, “P3” or “AL.”
• To change scan edge, push [8• SET ] after pushing [A• FUNC ] several
times until desired scan edge is appeared.
• “AL” for full scan, “P1”, “P2” and “P3” for programmed scan be-
tween the programmed scan edge channels as “1A”–“1b”,
“2A”–“2b” and “3A”–“3b”.
• To change the scan direction, push [Y] or [Z].
• When “dial” is assigned [VOL], rotate [VOL] to change the scan di-
rection. (p. 51)
e Push [D• CLR ] to stop the scan.
NOTE: Scan edges, 1A–3A/1b–3b, must be programmed in ad-
vance.
(Program them in the same manner as regular memory
channels. (p. 25))
If the same frequencies are programmed into the scan edges,
programmed scan will not proceed.
■ Memory (skip) scan
Memory scan repeatedly scans all programmed memory chan-
nels, except those set as skip channels.
q Push [C• MR ] to select memory mode, if necessary.
•“
X
” appears.
w Push [5• SCAN ] after pushing [A• FUNC ] to start the scan.
• To change the scan direction, push [Y] or [Z].
• When “dial” is assigned [VOL], rotate [VOL] to change the scan di-
rection. (p. 51)
e Push [D• CLR ] to stop the scan.
D Setting skip channels
In order to speed up the scan interval, you can set memory
channels you don’t wish to scan as skip channels.
q Push [C• MR ] to select memory mode, if necessary.
•“
X
” appears.
w Select a memory channel to set as a skip channel.
e Push [6•
SKIP ] after pushing [A• FUNC ] to toggle the skip setting
ON and OFF.
• “SKIP” appears when the channels is set as a skip channel.