Instruction Manual

ManualsBrandsIcom ManualsMarine RadioIC-V8

PAGER/CODE SQUELCH

• Receive accept/receive inhibit

➥ “Receive accept” (“SKIP” indicator does not appear) accepts

pager calls when the transceiver receives a signal with a code

the same as that in the code channel.

➥ “Receive inhibit” (“SKIP” indicator appears) rejects calls even

when the transceiver receives a code the same as that in the

code channel. Transmit codes should therefore be programmed

for “receive inhibit,” otherwise the transceiver will not reject un-

necessary calls.

• Pager/code squelch operation during channel indication

To use these functions in channel indication, the pager/code

squelch setting must be programmed with other memory contents

before selecting channel number indication.

PAGER/CODE SQUELCH

Code programming

An ID code MUST be programmed into code channel C0. Up to 6

transmit codes are programmable into code channels, C1 to C6, if

required.

q Push [✱•

OPTION

] after [A•

FUNC

] is pushed.

• Pager mode is selected.

• 100 MHz digit shows “P.”

w Push [8•

SET

] after [A•

FUNC

] is pushed.

• One of “CP” or “C0” to “C6” ﬂashes.

• “C0” is the ID code and “C1” to “C6” are

transmit code.

e Rotate [VOL] to select code channel C0.

• A different ID code must be programmed into each transceiver.

r Enter the desired 3-digit ID code via the

keypad.

t Rotate [VOL] to select a transmit code

channel from C1 to C6.

y Enter the desired 3-digit transmit code via

the keypad.

u Push [6•

SKIP

] after [A•

FUNC

] is pushed to

set the channel for “receive inhibit” or “re-

ceive accept.”

• When “receive inhibit” is set, “SKIP” ap-

pears as at right.

• Code channel C0 cannot be set as “receive inhibit.”

• See the following table for “receive accept” and “receive inhibit” de-

tails.

i Repeat steps t and y to set additional transmit code channels,

if desired.

o Push [#•

ENT

] or [PTT] to exit code set mode.

SKIP