Instruction Manual
44
10
PAGER/CODE SQUELCH
D Waiting for call from a specific station
q Set the operating frequency.
w Push [✱•
OPTION
] after [A•
FUNC
] is pushed.
• 100 MHz digit shows “P.”
e Wait for a call.
• When receiving a call, the caller’s ID or group code appears as
shown below.
• DO NOT push any digit keys while code channels C0 to C6 are dis-
played, or code channel contents are changed.
r Push [PTT] to send an answer back call and display the operat-
ing frequency.
t After confirming a connection push [✱•
OPTION
] after [A•
FUNC
] is
pushed to select code squelch operation, or repeat previous key
operation again to select non-selective calling system.
• PERSONS CALLS
This display appears when you are called
with your ID code and the calling station’s ID
code is 123.
• GROUP CALLS
This display appears when you are called
with the group code, 888, and 888 has been
programmed into code channel C6.
• ERROR INFORMATION
When the transceiver receives an incomplete
signal, “E” and previously received code ap-
pear.
SKIP
MR
F
TX
CP and flash.
MR
F
TX
Code channel
MR
F
TX
Previously received
code.
43
10
PAGER/CODE SQUELCH
‘‘
Pager operation
D Calling a specific station
q Program the needed code channel in advance (p. 41).
w Set the operating frequency.
•
Set the AF and squelch to the desired level as the normal operation.
e Push [✱•
OPTION
] after [A•
FUNC
] is pushed.
• Pager mode is selected.
• 100 MHz digit shows “P.”
r Select the desired transmit code channel:
➥ Push [8•
SET
] after [A•
FUNC
] is pushed.
➥ Rotate [VOL] to select the desired code channel.
➥ Push [#•
ENT
] to return to previous condition.
t Push [PTT] to transmit the pager code.
y Wait for an answer back.
• When the transceiver receives an answer back code, the function
display shows the other member’s ID or group code.
u After confirming a connection push [✱•
OPTION
] after [A•
FUNC
] is
pushed to select code squelch operation, or repeat previous key
operation again to select non-selective calling system.
• DO NOT push any digit keys while code channels C0 to C6 are dis-
played, or code channel contents are changed.
i Communicate with the other party as normal: push [PTT] to
transmit; release to receive.
Optional UT-108 required
MR
F
TX