Instruction Manual
46
11
OTHER FUNCTIONS
‘‘
Set mode
DD
Set mode entering
q Push [8•
SET
] after [A•
FUNC
] is pushed.
w Push [∫] or [√] to select item.
e Rotate [VOL] to select condition/value.
• To exit set mode, push [#•
ENT
].
DD
Repeater tone frequency
Selects tone encoder frequency for accessing
a repeater, etc. from one of 50 available fre-
quencies.
• 67.0–254.1 Hz (50 tones): 88.5 Hz (default)
DD
Tone squelch frequency
Selects frequency for tone squelch or pocket
beep operation from one of 50 available fre-
quencies.
• 67.0–254.1 Hz (50 tones): 88.5 Hz (default)
DD
DTCS code
Selects DTCS encoder/decoder code with po-
larity (N: normal/I: inverse) from one of 208
available codes.
• 023N/I–754N/I: 023N (default)
DD
Offset frequency
Sets the offset frequency for duplex (repeater)
operation within 0–20.00 MHz range.
DD
Reverse function
Turns the reverse function ON and OFF.
• Default: OFF
MR
F
TX
MR
F
TX
MR
F
D
TX
MR
F
TX
MR
F
TX
45
10
PAGER/CODE SQUELCH
‘‘
Code squelch
Code squelch provides communications with quiet standby since
you will only receive calls from stations which know your ID or
group code. Each push of [PTT] sends a 3-digit code in order to
open the receiving station’s code squelch prior to voice transmis-
sion.
q Set the operating frequency.
•
Set the AF and squelch to the desired level as the normal operation.
w Push [✱•
OPTION
] after [A•
FUNC
] is pushed.
• Repeat several times, if necessary.
• Code squelch mode is selected.
• 100 MHz digit shows “C.”
e Select the desired transmit code channel:
➥ Push [8•
SET
] after [A•
FUNC
] is pushed.
➥ Rotate [VOL] to select the desired code channel.
➥ Push [#•
ENT
] to exit code set mode.
r Operate the transceiver in the normal way (push [PTT] to trans-
mit; release [PTT] to receive).
t To cancel the code squelch, push [✱•
OPTION
] after [A•
FUNC
] is
pushed.
• 100 MHz digit shows “1” when the function is cancelled.
Optional UT-108 required
MR
F
TX