User Guide
38
9
SUBAUDIBLE TONES
D Setting subaudible tones for tone squelch operation
Separate tone frequencies can be set for tone squelch operation
rather than repeater operation (the same range of tones is avail-
able— see below). Like the repeater tones, these are set in set
mode.
q Select VFO or memory channel.
w Push [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
e Push [Y] or [Z] several times until “Ct” ap-
pears when selecting CTCSS, or “dt” ap-
pears when selecting DTCS.
•“ ” blinks when selecting CTCSS, or “”
blinks when selecting DTCS.
r Rotate [VOL] to select the desired sub-
audible tone.
t Push [#•
ENT
] to program the selected tone and exit
SET
MODE
.
When
SET MODE
is selected from memory mode.
y Push [A•
FUNC
], then push [C•
MR
] for 1 sec. to transfer the con-
tents to VFO.
• 3 beeps are emitted.
• VFO mode is selected automatically.
u Push [A•
FUNC
], then push [C•
MR
] for 1 sec.
• 3 beeps are emitted.
Steps y and u are necessary when overwriting the memory con-
tents permanently. The set tone frequency is used for temporary
operation only, therefore,these steps are not necessary.
• Available CTCSS tone frequency list
D
67.0
69.3
71.9
74.4
77.0
79.7
82.5
85.4
88.5
91.5
94.8
97.4
100.0
103.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8
136.5
141.3
146.2
151.4
156.7
159.8
162.2
165.5
167.9
171.3
173.8
177.3
179.9
183.5
186.2
189.9
192.8
196.6
199.5
203.5
206.5
210.7
218.1
225.7
229.1
233.6
241.8
250.3
254.1
MR
F
TX
MR
F
D
TX
IC-V8_New.qxd 03.2.6 10:20 Page 38 (1,1)