User Manual

24
6
MEMORY OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ General description
The transceiver has 207 memory channels including 6 scan
edge memory channels (3 pairs), and 1 call channel. Each of
these channels can be individually programmed with operat-
ing frequency (p. 00), duplex direction (p. 00), subaudible
tone encoder or tone squelch and its tone frequency (pgs. 00,
00) and skip information.* (p. 00)
In addition, a total of 10 memory banks, A to J, are available
for making groups with usage, etc.
*except for scan edge memory channels.
■ Memory channel selection
D Using the tuning dial
q Push [M/CALL(PRIO)]
once or twice to select
memory mode.
•“M” indicator appears
w Rotate the tuning dial to
select the desired mem-
ory channel.
• Programmed memory
channel can only be se-
lected.
D Using the [Y]/[Z] keys
z Push [MR/CALL] to select memory mode.
x Push [Y] or [Z] to select and set the desired
memory channel.
• Pushing [Y] or [Z] for more than 0.5 sec. acti-
vates a scan.
• If scan is activated, push [Y] or [Z] again to stop it.
D Using the keypad
z Push [MR/CALL] to select memory mode.
x Push [
ENT C] to activate the keypad for nu-
meral input.
c Push 3 appropriate digit keys to input a chan-
nel number.
• When inputting non-programmed channel num-
bers, the previous memory channel appears.
• Push only 1 appropriate digit key, [ MONI 1], [ SCAN 2]
or [ PRIO 3], then push [ VOL Z ✱] or [ SQL Z #] to se-
lect scan edge channels. “✱” and “#” can be used
for A and b respectively.
MR/CALL
Y/Z
MR/CALL
Y/Z
Push [M/CALL(PRIO)] to select
memory mode.
Appears