User Manual

28
6
MEMORY OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D Memory/call➪call/memory
q Select the memory/call channel to be transferred.
➥
Push [M/CALL(PRIO)] to select memory mode, then ro-
tate the tuning dial to select the desired memory channel.
➥ Push [M/CALL(PRIO)] for 1 sec. to select the call channel.
w Push [MW(S.MW)] momentarily.
•“M” indicator and “– –” indication blink.
e Rotate the tuning dial to select the target memory channel.
•“C” blinks when the call channel is selected.
• Scan edge channels, 1A/1b, 2A/2b, 3A/3b, can also be selected.
r Push [MW(S.MW)] for 1 sec. to transfer the selected mem-
ory/call channel contents to the target memory.
• The targeted memory and transferred contents are indicated.
z Select the memory/call channel to be trans-
ferred.
➥ Push [MR/CALL] to select memory mode,
then select the desired memory channel
via [Y]/[Z] or keypad.
➥ Push [MR/CALL] for 1 sec. to select the
call channel.
x Push [FUNC], then [
CLR A(MW)] momentarily.
•“M” indicator and “– –” indication blink.
c Push [Y]/[Z] to selected the target memory
channel.
•“C” blinks when the call channel is selected.
• Scan edge channels can also be selected.
• The keypad cannot be used for the selection.
v Push [FUNC] then push [ CLR A(MW)] for
1 sec. to transfer the selected memory/call
channel contents to the target memory.
• The targeted memory and transferred contents
are indicated.
MR/CALL
MW
[Y]/[Z]
[EXAMPLE]: Transferring memory channel 30 contents to channel 31.
Select the target channel. Push for 1 sec.
Push then push for 1 sec.
S.MW
MW
Select the memory channel, then push .
S.MW
MW
Select the memory channel, push then push .