User Manual

6 MEMORY OPERATION

[EXAMPLE]: Clearing memory channel 20.

Push to select VFO. Rotate for selecting memory channel.Push momentarily.

V/MHz

SCAN

S.MW

Push any switch.Push briefly, then push again for 1 sec.

S.MW

Beep

“

■ Memory clearing

Contents of programmed memories can be cleared (blanked),

if desired.

q Push [V/MHz(SCAN)] to select VFO mode.

w Push [MW(S.MW)] momentarily.

•“M” indicator and the memory channel number blink.

e Rotate the tuning dial to select the memory channel to be

cleared.

• Memory channels not yet programmed are blank.

r Push [MW(S.MW)] briefly, then push [MW(S.MW)] again

for 1 sec.

• 3 beeps sound, then the frequency is cleared.

•“M” indicator blinks continuously.

• Scan edges, 1A/1b, 2A/2b, 3A/3b, and the call channel cannot

be cleared.

☞ This operation must be performed within 1.5 sec.

t Push any switch, except [MW(S.MW)], to return to VFO

mode.

☞NOTE: Be careful!— the contents of cleared memories

CANNOT be recalled.