User Manual

30
6
MEMORY OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Channel names programming
Each memory channel and the call channel can be pro-
grammed with an alphanumeric channel names for easy
recognition and can be indicated channel independent.
Names can be a maximum of 6 characters— see the table
below for available characters.
NOTE:
Scan edge channels CANNOT be programmed with al-
phanumeric channel names?
q Push [M/CALL(PRIO)] to select memory mode.
w
Rotate the tuning dial to select the desired memory channel.
e Push [MONI(ANM)] for 1 sec.
• 3 beeps sound.
r Push [SET(LOCK)] to select the channel names program-
mable condition.
• Frequency readouts disappear.
t Rotate the tuning dial to select the desired character.
• The selected character blinks.
y Push [SET(LOCK)] or [MW(S.MW)] to move the cursor to
left or right, respectively.
u Repeat steps t and y until the desired channel names
are displayed.
i Push [V/MHz(SCAN)] to program the name and exit chan-
nel names programmable condition.
o Push [MONI(ANM)] for 1 sec. to return to frequency indi-
cation if desired.
(1)
(B)
(L)
(V)
(+)
(2)
(C)
( M )
( W )
(–)
(3)
(
D )
(N)
(X)
(=)
(4)
(E)
(O)
(Y)
(✱)
(5)
(F)
(P)
(Z)
(/)
(6)
(G)
(
Q )
(space)
(7)
(<)
(
H )
(
R )
(>)
(8)
(I)
(S)
(|)
(9)
(J)
(T)
(0)
(A)
( K )
(U)
[EXAMPLE]: Programming “CLUB” into memory channel 1.
Push .
V/MHz
SCAN
Select memory channel 1,
then push for 1 sec.
MONI
ANM
Push or to move
the cursor.
SET
LOCK
S.MW
MW
Rotate to select the
character.
Repeat
previous
steps.