User Manual

46
10
DTMF MEMORY ENCODER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Transmitting a DTMF code
D Automatic transmission (DTMF memory)
z Push [FUNC] then [ LOW 6(DTMF)] to turn the
DTMF encoder ON.
•“d” appears in place of the 100 MHz digit.
x Push [ SET B(D-OFF)] to enter the DTMF mem-
ory programming condition.
c Push [Y] or [Z] to select the desired channel.
v Push [PTT] to transmit the selected memory.
• Exit the programming condition automatically.
• Each push of [PTT] transmits the DTMF code.
b Push [FUNC] then [ SET B(D-OFF)] to cancel the
DTMF encoder.
• When the DTMF encoder is turned ON continuously,
each push of the PTT transmits the previously se-
lected DTMF code.
D Transmitting a DTMF memory directly
z Push [DTMF-S] to turn the DTMF memory di-
rect selection ON.
• The function indicator (microhpne) lights green.
x Push the desired DTMF channel number.
•“0” to “9” are available for channel numbers.
• Automatically transmits the selected DTMF code.
NOTE: When no DTMF code programmed channel
number is pushed, transmits for 1 sec. with-
out DTMF code.
c Push [DTMF-S] again to deactivate the DTMF
meory direct selection.
D Manual transmission
z Push [DTMF-S] to turn the DTMF memory di-
rect selection ON.
• The function indicator (microhpne) lights green.
x Push one of “A” to “F” key momentarily, then
push the desired DTMF keys.
• A: [ CLR A(MW)] B: [ SET B(D-OFF)],
C: [ ENT C(T-OFF)] D: [
SQL
Y D(MUTE)],
E: [✱(TONE-1)] F: [ SQL Z #(16KEY-L)]
• Automatically transmits without pushing PTT.
• The first code, one of “A” to “F”, does not transmit-
ted. DTMF code transmission started from the 2nd
code.
c Push [DTMF-S] again to deactivate the DTMF
meory direct selection.
DTMF-S
DTMF-S
DTMF