User Manual

48
11
POCKET BEEP AND TONE SQUELCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Pocket beep operation
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the transceiver.
D Waiting for a call from a specific station
q Set the operating frequency.
w Push [SET(LOCK)] to enter set mode.
e Push [SET(LOCK)] or [MW(S.MW)] several times until “Ct”
for tone squelch or “dt” for DTCS squelch appears.
r Rotate the tuning dial to select the desired tone squelch
frequency or DTCS code and porality.
t Push [V/MHz(SCAN] to exit set mode.
y Push [TONE(T-SCAN)] several times to indicate “” for
tone squelch or “ D ” for DTCS squelch in the function
display.
u When a signal with the matched tone is received, the
transceiver emits beep tones and flashes “”.
• Beep tones sound for 30 sec and “” flashes. To stop the beeps
and flashing manually, push any key. When the beep tones are
not stopped manually, “” continues flashing until step i.
i Push [PTT] to answer.
o Push [TONE(T-SCAN)] several times to cancel the func-
tion.
z Set the operating frequency.
x Program the CTCSS tone frequency or DTCS code in set
mode.
• See p. 18 for programming details.
c Push [FUNC] then [iT SQLS] to turn the pocket beep
ON.
v When a signal with the matched tone is received, the
transceiver emits beep tones for 30 sec. and flashes
“S”.
b Push [PTT] to answer or push [clr A(MW)] to stop the
beeps and flashing.
• Tone squelch is automatically selected.
• Pushing [FUNC] then [oTSQL] also selects the
tone squelch.
n To cancel the function, push [FUNC] then [GT-OFF].
D Calling a waiting station using pocket beep
A subaudible tone matched with the station’s CTCSS tone fre-
quency or 3-digit DTCS code with polarity is necessary. Use
the tone squelch on the next page or a subaudible tone en-
coder (pgs. 00, 00)
■ Tone squelch operation
The tone squelch opens only when receiving a signal with the
same pre-programmed subaudible tone.
Tone squelch frqueency setting DTCS code setting