User Manual

58
11
OTHER FUNCTIONS
New2001
11
DD
DTCS polarity
Sets DTCS polarities for transmission and reception from
“nn,” “nr,” “rn” and “rr.” (default: nn)
DD
Offset frequency
Sets the duplex offset frequency within 0 to 20 MHz range.
During duplex (repeater) operation, transmit frequency (or re-
ceive when reverse function is set to ON) shifts the set fre-
quency.
(default value may differ depending on operating frequency
band and versions)
DD
Tuning step
Selects tuning step from 5, 10, 12.5, 15, 20, 25, 30 and
50 kHz for [DIAL] or [Y]/[Z] operation.
(default value may differ
depending on operating frequency band and versions)
DD
Scan resume timer
Selects scan resume timer from SCT-15 (default), SCT-10,
SCT-5 and SCP-2.
• SCT-15/10/5 : Scan pauses for 15/10/5 sec., then re-
sumes.
• SCP-2 : Pause on a signal until signal disap-
pears, then resumes 2 sec. after the sig-
nal disappears.
DD
Channel skip setting
Sets channel skip setting from ON and OFF for memory skip
scan operation.
This item appears when set mode is accessed from memory
mode only.
MAIN
T X
M
MAIN
T X
M
SKIP
• “~” appears
when set to “On.”
• Default setting
MAIN
T X
M
MAIN
T X
M
MAIN
T X
M
MAIN
T X
DUP
MAIN
T X
DTCS
M
MAIN
T X
DTCS
M
• Transmit : normal
Receive : normal
(default)
• Transmit : normal
Receive : reverse
IC-2720H_1.qxd 02.12.18 13:02 Page 58 (1,1)