Operation Manual

7-10
7
FUNCTIONS FOR RECEIVE

Dualwatch operation
Dualwatch simultaneously monitors two frequencies.
This transceiver has 2 independent receiver circuits,
the Main and Sub bands, so that you can use Dual-
watch with no compromises, even on different bands
and modes.
q Set the desired mode in the Main and Sub bands.
w Push [DUALWATCH] to select the Dualwatch opera-
tion.
• To equalize the SUB band frequency and mode to that
of the Main band, hold down [DUALWATCH] for 1 sec-
ond. This Quick Dualwatch function can be turned OFF
in the Others set screen. (p. 15-13)
(SET [F-7] > OTHERS [F-5] > Quick Dualwatch)
e Rotate [MAIN DIAL] or [SUB DIAL] to set the de-
sired frequency.
Normally, the transceiver transmits on the Main band.
During Dualwatch operation, you can transmit on the
Sub band by doing the following procedures:
• Push [SPLIT] to turn ON the Split function.
• Push [CHANGE] to switch the settings, such as the oper-
ating frequency, operating mode, and so on, between the
Main and Sub bands.
NOTE:
• A beat note may be heard, depending on the fre-
quency combination (3.5 MHz and 7 MHz, and so
on).
• Receiver sensitivity may be decreased when the
same frequency band and the same antenna are
selected during Dualwatch.
[MAIN DIAL] [SUB DIAL]
[CHANGE] [DUALWATCH]
[SPLIT]
• During the Dualwatch operation
• When switching the settings between the Main
and Sub bands
• When the Split function is ON
Appears on the SUB band