User Manual

SET MODE

Preampliﬁer controller for 430(440) MHz

Switch the preamplifier control capability ON and

OFF. When using the optional AG-35, ON must be se-

lected. Otherwise, the preampliﬁer is never activated.

DO NOT connect any equipment, such as an SWR

or power meter, between the transceiver and pre-

amplifier. In such case, the preamplifier may not

activate properly.

P.A MP P.A MP

Preampliﬁer controller for 1200 MHz

Switch the preamplifier control capability ON and

OFF. When using the optional AG-1200, ON must be

selected. Otherwise, the preamplifier is never acti-

vated.

DO NOT connect any equipment, such as an SWR

or power meter, between the transceiver and pre-

amplifier. In such case, the preamplifier may not

activate properly.

P.A MP P.A MP

CI-V address

To distinguish between equipment, each CI-V trans-

ceiver has its own Icom standard address in hexa-

decimal code. The IC-910H’s address is 60H.

When 2 or more IC-910Hs are connected to an op-

tional CT-17

V LEVEL CONVERTER

, select a different

address for each IC-910H in the range 01H to 7FH.

CI-V baud rate

Select transfer rate for CI-V remote control from Auto,

300, 1200, 4800, 9600 and 19200 bps.

CI-V transceive

Transceive operation is possible with the IC-910H

connected to other Icom transceivers or receivers.

When “on” is selected, changing the operating fre-

quency, operating mode, etc. on the IC-910H auto-

matically changes those of connected transceivers (or

receivers) and vice versa.

IC-910H-6.qxd 02.4.25 09:35 AM Page 59 (1,1)