User Guide

10
4
CONNECTIONS AND INSTALLATIONS
■ When install into system rack
The ID-RP2C/D/V are designed to install into the 19-
inch rack (EIA standard) directly.
Use the supplied bolts with the rack when fixing the ID-
RP2C/D/V.
We recommend to use the rack that has rails due to
the weigh of the ID-RP2D and ID-RP2V is approx.
6.2 kg
(13.7 lbs) and approx. 7.5 kg (16.5 lbs), respec-
tively.
■ Rubber feet attachment
Attach the supplied rubber feet onto the bottom of the
ID-RP2C/D/V as shown at left when not installed into
19-inch rack. Desktop operation can be performed.
■ Grounding
To prevent electrical shock, television interference
(TVI), broadcast interference (BCI) and other problems,
ground the transceiver through the GROUND terminal
on the rear panel.
For best results, connect a heavy gauge wire or strap
to a long earth-sunk copper rod.
Make the distance between the [GND] terminal and
ground as short as possible.
R WARNING: NEVER connect the [GND] ter-
minal to a gas or electric pipe, since the connection
could cause an explosion or electric shock.
q • Cross section
w