User Guide

7
37
REPEATER SETTINGS
■ ID-RP2C setting
A LAN cable (patch connection; purchase separately) is
used for the ID-RP2C setting.
And the fixed IP address that can be communicated to
the ID-RP2C must be set to the PC in advance.
Refer to the instruction manual of the PC or LAN card
for IP address setting details.
q Start up Windows.
w Connect the ID-RP2C [10BASE-T] connector and
the PC’s LAN port through a LAN cable (Patch con-
nection; purchase separately), then turn the ID-
RP2C power ON.
e Start up the utility for ID-RP2C.
•Double click “ID-RP2C” icon on the desktop, or select
the ID-RP2C utility from “Program” in “Start” menu.
r The screen as at left appears.
•Check the IP address and the UDP port number using
the “Network Setup” as described in w Option menu in
advance. (p. 38)
• Click [Read].
t “Network Password” screen appears.
Enter the password then click [OK].
•Enter the password with alphanumeric characters (case
sensitive).
•“PASSWORD” (capital letters) is the default password.
y Reads the ID-RP2C settings then the screen as at
left appears.
•When the error message screen appears, confirm the
LAN cable connections, IP address and subnet mask for
the PC.
•And check the IP address and UDP port settings are set
to “172.16.0.1 (default)” and “20319 (default)” respec-
tively in “Network Setup” screen by selecting “Network
Setup…” in “Option” menu.
u Set the specified call sign, IP address, repeater
configuration and microwave link repeater condi-
tions.
• After the setting, click [Write] to transfer and program the
setting into ID-RP2C.
• See the next page for the details of each item.
i Quit the utility.
• Select “Exit” in “File” menu or click “ ” on the title bar.
Click
Enter “PASSWORD”
then click.
Click