User Guide

39
7
REPEATER SETTINGS
D ID-RP2C utility screen— continued
q w
e r
t
y
u
i
!1
!0o
!9
@0
!2
!3
!4
!5
!6
!7
!8
t Firmware (Revision) indication
Shows the revision number of the programmed
firmware in the ID-RP2C.
y Callsign (Call sign)
Enter the call sign (local repeater).
Usable characters are; A to Z
(capital letters only), 0
to 9 and some symbols (!, “, #, $, %, &, ‘, (, ), *, +, ,,
-, ., /, :, ;, <, =, >, ?, @, [, \, ], ^, _).
u Repeater ID
Enter the repeater identity code within 1 to 15.
The repeater ID code is an identification number al-
located in each repeater, and a different code must
be allocated for each repeater that operates in the
same zone.
IMPORTANT!:
NEVER duplicate the ID number in the zone.
A unique ID number within 1 to 15 range must be
entered. Otherwise the communications between
local repeaters won’t function properly.
The same repeater ID code can be allocated to
the repeater if the repeater operates in a differ-
ent zone.
i Config
(Local repeater configuration)
Selects the connected local repeater type (voice or
data)
for each [LOCAL RPT— CONT I/O] connector.
Click [Z] button then select the repeater type from
the displayed list. The selected repeater type is dis-
played in the text box below.
The displayed contents cannot be edit.
o Check box((1) to (4))
Click to display the check mark, “✔,” in the corre-
sponding connector name. The names correspond
to [CONT I/O] connectors on the ID-RP2C rear
panel ((1), (2), (3) and (4) from the left).
IMPORTANT!:
When no check mark is displayed, the local re-
peater cannot be operated even if the repeater is
connected to the system.