User Guide

6
3
PANEL DESCRIPTIONS
■ ID-RP2D (Front panel)
q POWER SWITCH [POWER]
The power switch for ID-RP2D.
The LED indicator located at right lights when the
power is turned ON.
w HIGH/LOW POWER SELECT SWITCH [H/L]
Selects the transmit output power High (approx.
10 W)
and Low (approx. 1 W).
e SERVICE CONNECTOR [SERVICE] (p. 41)
Connects a PC via an USB cable (A-B type; purchase
separately)
to set the both transmit and receive fre-
quencies.
qwe
■ ID-RP2D (Rear panel)
q ANTENNA CONNECTOR [ANT] (p. 11)
Connect the optional AH-108 1.2 GHz Collinear an-
tenna.
When both ID-RP2D and ID-RP2V is composed in
a site, an antenna filter, such as bandpass filter, res-
onator, or so, should be installed between the ID-
RP2D and antenna to protect the ID-RP2D recep-
tion from interference of the ID-RP2V downlink
signal.
w COOLING FAN
e POWER CONNECTOR [DC13.8V] (p. 11)
Connects to ID-RP2C via the supplied DC power
cable (OPC-1309) to be supplied the DC power.
r [CONT I/O] (p. 11)
Connects to ID-RP2C via the supplied control cable
for received or transmitted serial data communica-
tion.
t GROUND TERMINAL [GND] (p. 10)
Connects to a ground to prevent electrical shocks,
TVI, BCI and other problems.
qwer t