Operation Manual

5
2
PANEL DESCRIPTION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
!3 KEY ICON (p. 6)
Shows the preset function of the softkeys on the front pan-
el.
!4 TIME ZONE INDICATOR
Shows the current time when GPS data is received, or ➥
the time is manually entered.
  •WhentheGPScurrenttimeisinvalid,“??”willblinkevery2
seconds instead of current time. After 23.5 hours has passed,
“NO TIME” is displayed.
  •“??”willblinkevery2 secondsinstead ofthe currenttime,
after 4 hours have passed from the time when the time was
manually entered. The manually entered time is held for only
23.5 hours, and after that, “NO TIME” is displayed.
“LOCAL” is displayed when the offset time is set. ➥
“MNL” is displayed when the time is manually entered. ➥
“UTC” is displayed when the GGA, GLL, and GNS GPS ➥
sentence format is included in the GPS signal.
The date information is displayed when the RMC GPS ➥
sentence format is included in the GPS signal.
“NO TIME” is displayed when no GPS receiver is con- ➥
nected, and no time is manually entered.
NOTE for the IC-M323 and IC-M324:
These models do not come with a built-in GPS receiver.
Therefore an external GPS receiver needs to be con-
nected, or the time needs to be manually entered for
the time zone indicator to be displayed.
!5 POSITION INDICATOR
Shows the current position when position data is re- ➥
ceived, or the position is manually entered.
  •Whenthepositiondataisinvalid,“??”mayblinkevery2sec-
onds instead of position. The last position is held for only
23.5 hours, and after that, “NO POSITION” is displayed.
  •“??” will blink every 2 seconds instead of position, after 4
hours have passed from the time when the position is manu-
ally entered. The manually entered position is held for only
23.5 hours, and after that, “NO POSITION” is displayed.
“NO POSITION” is displayed when no GPS receiver is ➥
connected, and no position is manually entered.
!6 SCAN INDICATOR
“SCAN 16” is displayed during a Priority scan; “SCAN” ➥
is displayed during a Normal scan. (p. 17)
“DUAL 16” is displayed during Dualwatch; “TRI 16” is ➥
displayed during Tri-watch. (p. 18)
!7 LOCAL ICON (p. 12)
Displayed when the Attenuator function is turned ON.
*For only U.S.A. and Australian version transceivers.