Operation Manual

38
7
DSC OPERATION
New2001
■ Making DSC calls
Making a Position Report call (continued) D
Push [CALL] to make a Position Report Call. r
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechannel
becomes clear.
After the Position Report Call has been transmitted, the t
transceiver automatically returns to the normal operating
mode.
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both position
and time have been manually entered, the screen as shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
*For only IC-M323G and IC-M324G.
Push [CHG], then edit your latitude and longitude position ➥
and UTC time.
 •SelectadesirednumberusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
 •SelectN(Northlatitude)orS(Southlatitude)whenthecursor
is on the ‘N’ or ‘S’ position.
 •SelectW(Westlongitude)orE(Eastlongitude)whenthecur-
sor is on the ‘W’ or ‘E’ position.