Operation Manual

16
4
BASIC OPERATION
New2001
■ Entering a Call channel data
You can enter data in Call channel in each channel group for
quick recall.
Select the desired channel group (INT, USA, CAN, ATIS, q
or DSC) to be entered. (p. 12)
Hold down [16/C] for 1 second to select the Call channel of w
the selected channel group.
 •“CALL”andtheCallchannelnumberisdisplayed.
Hold down [16/C] again for 3 seconds (until a long beep e
changes to 2 short beeps) to enter the Call channel entry
mode.
Rotate Dial or push [ r ∫]/[√] to select a channel.
Push [ENT] to save the displayed channel as the Call t
channel.
 •Push[CLEAR]tocancel.
Entering a ■ Channel name
Enter a name of up to 10 characters.
Capital letters, 0 to 9, some symbols, (! " # $ % & ' ( ) * + , – .
/[\]^_:;<=>?)andaspacecanbeentered.
Push [ q ∫]/[√](CH) to select a channel.
 •First, canceltheDualwatch,Tri-watchorScan function,ifacti-
vated.
Push [NAME] to open the channel name enter screen. w
 •Acursorisdisplayedontherstcharacter.
Enter the desired channel name in the following manner: e
 •SelectadesiredcharacterusingDial,or[∫]/[√]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
 •Push[123],[!$?],or[ABC]toselectacharactergroup.
 •Select“SPACE,”thenpush[ENT]toenteraspace.
 •Select“DELETE,”thenpush[ENT]todeleteacharacter.
 •Push[CLEAR]tocancelandreturntothepreviousscreen.