Operation Manual

48
7
DSC OPERATION
New2001
■ Making DSC calls
Making a Position Reply call (continued) D
Manual Reply:
Enter “POSITION REPLY” in the DSC CALLS menu. q
MENU ➪ DSC Calls ➪ Position Reply
(Push [MENU].) (Rotate Dial, then push [ENT].)
 •IfnoPositionRequestcallisreceived,thePositionReplyitem
will not be displayed.
 •Push[EXIT]toreturntothenormaloperatingmode.
 •Push[BACK]toreturntothepreviousscreen.
Select a desired Position Request call to reply to, using w
Dial or [Y]/[Z], then push Dial or [ENT].
The Position Reply call confirmation screen is displayed. e
Push [CALL] to make an acknowledgement call.
While transmitting the reply call, the screen shown below r
is displayed, and then returns to the normal operating
mode.
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both position
and time have been manually entered, the screen as shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
*For only IC-M423G and IC-M424G.
Push [CHG], then edit your latitude and longitude position ➥
and UTC time.
 •SelectadesirednumberusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
 •SelectN(Northlatitude)orS(Southlatitude)whenthecursor
is on the ‘N’ or ‘S’ position.
 •SelectW(Westlongitude)orE(Eastlongitude)whenthecur-
sor is on the ‘W’ or ‘E’ position.