Owners manual

44
8
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CH 70 SQL Level (Default: 5)
Adjust the Squelch level for Channel 70 to between 1 and
10, or Open.
L“ ” is displayed when adjusted to Open.
A higher level blocks weak signals, which enables you to
send a DSC call.
DST at PW Off (Default: Valid)
This function enables you to send Distress calls even while
the transceiver is OFF.
Valid: You can send Distress calls by holding down
[DISTRESS], even while the transceiver is OFF.
Invalid: You cannot send Distress calls while the
transceiver is OFF.
Loop Test
This function sends DSC signals to the receiving AF circuit
to compare the sending and receiving signals at the AF
level.
Push [ENT] to start the Loop Test.
L When the sending and receiving DSC signals match, “OK” is
displayed.
NOTE: If “NG” is displayed, either or both the sending and
receiving DSC circuits have a problem. In that case, you
will have to send the transceiver to your dealer for repair.