Owners manual
Table Of Contents
- Front cover
- IMPORTANT
- FEATURES
- EXPLICIT DEFINITIONS
- IN CASE OF EMERGENCY
- PRECAUTIONS
- RECOMMENDATION
- INFORMATION
- DISPOSAL
- COUNTRY CODE LIST
- TABLE OF CONTENTS
- 1. OPERATING RULES
- 2. SUPPLIED ACCESSORIES AND ATTACHMENTS
- 3. PANEL DESCRIPTION
- 4. PREPARATIONS
- 5. BASIC OPERATIONS
- 6. SCAN
- 7. DUALWATCH/TRI-WATCH
- 8. DSC OPERATION
- 9. OTHER FUNCTIONS
- 10. MENU SCREEN
- 11. BATTERY CHARGING
- 12. OPTIONAL SPEAKER MICROPHONE
- 13. TROUBLESHOOTING
- 14. SPECIFICATIONS AND OPTIONS
- 15. CHANNEL LIST
- 16. SAFETY TRAINING INFORMATION
- INDEX
- Back cover
64
13
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
PROBLEM POSSIBLE CAUSE SOLUTION REF.
You cannot turn ON the
transceiver.
• The Battery is exhausted or over
discharged.
• The Battery pack is not correctly attached.
• Recharge the battery pack.
• Correctly attach the battery pack.
p. 61
p. 2
Little or no sound
comes from the
speaker.
• The squelch level is set too high.
• The volume level is set too low.
• The speaker has been exposed to water.
• Water has entered to the speaker
microphone connector.
• Set the squelch to the threshold point.
• Set the volume to a suitable level.
• Remove the water using the AquaQuake
function.
• Dry the speaker microphone connector.
p. 13
p. 15
–
You cannot transmit
• Some channels are preset for low power
or receive only by regulations.
• The battery is exhausted.
• The battery is overcharged.
• The output power is set to low.
• Change channels.
• Recharge the battery pack.
• Conrm that the battery voltage is correct.
• Push the software key below
to select
high power.
p. 14
p. 61
p. 5
Scan does not start • Favorite channels are not set. • Set the Favorite channels. p. 17
No beeps sound • Key Beep is set to OFF. • Turn ON the Key Beep on the
“Conguration” screen.
p. 57
You cannot send DSC
calls
• MMSI (DSC self ID) code is not entered.
• DSC Switch is set to OFF.
• Enter the MMSI (DSC self ID) code.
• Turn ON the DSC Switch in the Menu.
p. 9
p. 42
You cannot receive
GPS position data
• The built-in GPS antenna is obstructed,
which interrupts the GPS signals from the
satellites.
• Use the transceiver in a place where
nothing interrupts the satellite signal.
–