User's Guide

Figure 4: pole bracket + rear bracket Figure 5: radar installed on the pole bracket
c. The angles
2 angles determine the installation and accuracy of the measurements:
Horizontal (, with reference to the vehicle movement axis): ALWAYS 45°, where the base of the
radar is aligned with a point situated halfway between the parallel and perpendicular axis of the
road. Position the mounting foot in parallel with the vehicle movement, as indicated above.
When you position the radar on the bracket, it will be automatically positioned at 45° (see Figure
4 and Figure 5).
Vertical (): determined by the software according to the height of the installation and the
distance to the vehicle movement axis. This angle will be adjusted automatically after you have
sent the installation parameters to the radar and it has switched to "measurement" mode. The
software makes it possible to fine tune this angle according to the slope of the road and/or the
inclination of the post.
2. CONFIGURING THE RADAR
Launch the IcomSoft TMS-SA software and go through the following steps:
1. Choose “Connect” followed by “Connect to a device” and then “Connect via Bluetooth”. The
software will search for Bluetooth devices and display the available Bluetooth devices on the
screen.
2. Choose the device to connect to and click “Connect” as shown in Erreur ! Source du renvoi
introuvable..
3. Follow the instructions given by the assistant.