User's Manual
Table Of Contents
- 1. Quick Specifications
- 2. Pin Descriptions
- 3. Electrical Specifications
- 3.1. Absolute Maximum Ratings
- 3.2. Operating Conditions
- 3.3. General Purpose I/O
- 3.4. Debug & Programming
- 3.5. Clocks
- 4. Mechanical Data
- 4.1. Module Dimensions
- 4.2. Recommended PCB Land Pad
- 5. Module Marking
- 5.1. Mechanical Enclosure
- 6. Regulatory Statements
- 6.1. FCC Statement:
- 6.2. FCC Important Notes:
- 6.3. IC Statement:
- 6.4. IC Important Notes:
- 6.5. CE Regulatory:
- 7. Solder Reflow Temperature-Time Profile
BMD-ICN-1 Datasheet v1.0 CONFIDENTIAL Page 10 of 11
6.4. IC Important Notes:
1. The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user manual of the end product.
The user manual which is provided by OEM integrators for end users must include the following information in
a prominent location.
2. To comply with IC RF exposure compliance requirements, the antenna used for this transmitter must not be
co‐located or operating in conjunction with any other antenna or transmitter, except in accordance with IC
multi‐transmitter product procedures.
3. The final system integrator must ensure there is no instruction provided in the user manual or customer
documentation indicating how to install or remove the transmitter module except such device has
implemented two‐ways authentication between module and the host system.
4. The host device shall be properly labelled to identify the module within the host device. The final end
product must be labeled in a visible area with the following: “Contains IC: 3673A-BMD1”.
Any similar wording that expresses the same meaning may be used.
The IC Statement below should also be included on the label. When not possible, the IC Statement should be
included in the User Manual of the host device.
“This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le onctionnement.”
6.5. CE Regulatory:
This device has been tested and have been found compliant against the following standards. OEM integrators
should consult with qualified test house to verify all regulatory requirements have been met for their
complete device.
From Directive 2006/95/EC:
EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011
From R&TTE Directive 1999/5/EC:
ETSI EN 300 440-1 V 1.6.1
ETSI EN 300 440-2 V 1.4.1
EN 62479:2010
From Directive 2004/108/EC:
ETSI EN 301 489-3 V1.6.1
ETSI EN 301 489-1 V1.9.2