User Manual

HOW TO USE THE SPEED RING
The included speed ring can be used to control the speed
of the walking belt. The speed ring functions just like the
Speed increase and decrease buttons, except that it can-
not be used to start the manual mode or a workout.
To connect the speed ring to the console, simply press
a button on the speed ring. The console will display the
connection status of the speed ring. Once the speed ring
is connected, a battery icon will appear on the screen to
indicate the battery life of the speed ring.
To replace the battery in the speed ring, follow the instruc-
tions below.
1. Remove the cover by press-
ing down on the cover in
the direction shown by the
arrow. Then, pull the cover
off the speed ring.
2. Using a small tool such as
a pin or a thin screwdriver,
press down on the clip hold-
ing the old battery in place.
Then, remove the old bat-
tery. Insert a new battery by
pressing the battery against
the clip first, and then press
the battery into place.
3. Press the cover back into
place. Press a button on the
speed ring to connect it to
the console.
FCC Information—The speed ring complies with Part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
The speed ring has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. The speed ring generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
IC (Canada—Industry Canada)
This device complies with ICES-003 of Industry Canada
rules. Operation of this device is subject to the following
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
Avis de conformité á la réglementation d’Industrie
Canada
Cet appareil est conform á la norme NMB-003 du Industrie
Canada. L’utilisation de ce dispositive est autorisée seule-
ment aux deux conditions suivantes :
1. il ne doit pas produire de brouilage.
2. l’utilisateur du dispositive doit étre prêt á accepter tout
brouillage radioélectrique reçu, méme si ce brouillage
est susceptible de compromettre le fonctionnement du
dispositive.
IMPORTANT: The speed ring emits radio frequency
energy, but the radiated output power is far below the
FCC and IC radio frequency exposure limits. The speed
ring complies with FCC and IC RF radiation exposure
limits for an uncontrolled environment.
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the speed ring.