User's Manual

5
Rotate the Round Duo
The Duo can be worn with the classic dial face displayed or with
the LED face ready for action. To rotate the case, rst lift the lower
edge of the case out of the cradle as shown at the left. Next,
rotate the case clockwise or counterclockwise. Then, press the
case back into the cradle.
Flip the Square Duo
The Duo can be worn with the classic dial face displayed or with
the LED face ready for action. The direction that you will ip the
case depends on which face is displayed.
When the LED face is displayed, slide the case to the left, ip the
case, and then slide the case back to the right.
When the dial face is displayed, slide the case to the right, ip the
case, and then slide the case back to the left.
Fasten the Band
Wrap the band around your wrist, insert the tip of the band through the buckle, and insert the prong into the desired hole in
the band. Then, insert the tip of the band through the two keepers. Make sure that the band is slightly loose on your wrist.
Reverse these actions to unfasten the band.
Note: As with any watch or jewelry, a very small percentage of users may experience skin irritation while wearing the band. If
you experience any skin irritation, discontinue wearing the band and carry the Duo independently in your pocket. If you have
questions, send email to [e-mail].
Wear The Duo
Periodically remove the Duo and clean the band with a damp cloth and one or two drops of mild liquid soap. Then, rinse the
band with a small amount of clean water. Do not use abrasive cleaners to clean the band, and do not place the Duo or the
band in a washing machine or dryer. Allow the band to dry thoroughly before you put it back on your wrist.
Clean The Band