User's Manual
Table Of Contents
- Introduction
- What's in the package?
- Register your ICON ProAudio product to your personal account
- Features
- Front Panel Layout
- Rear panel layout
- Getting Started
- Connecting your ikeyboard Nano controller
- Download the Windows driver from your “Personal User Page at www.iconproaudio.com”
- Installing iMapTM Software for Windows
- Assigning MIDI functions with iMapTM
- iMapTM ikeyboard Nano software panel
- Firmware upgrade
- Restore the factory default settings
- Reverse sustain pedal connector polarity
- Velocity curve
- Specifications
- Services
15
2.0 General setting to the keyboard
2.1 “Save le” button
Click this button to save your current settings for the ikeyboard Nano. The le is an
“ikeyboard Nano” le.
2.2 “Load le” button
Click this button to load a previously saved “. ikeyboard Nano” setting le for your
ikeyboard Nano.
2.3 “Send Data” button
Click this button to upload the iMap
TM
software settings to your ikeyboard Nano via USB
connection.
(Note:You must have connected your ikeyboard Nano to your Mac/PC, otherwise the
settings upload will not be successful.)
2.2
2.5
2.4
2.1 2.3
Section 2
2.4 “MIDI Devices” button
Click this button, a MIDI device select window will appear as shown in diagram 10. Please
select “ICON ikeyboard Nano” for the MIDI Out Devices.
(Note: Please make sure you have pressed this button every time you launched iMap,
select your ICON product on the MIDI input-output Device pop-up menu to make sure the
communication between iMap and your ICON product is created successfully.)
Diagram 10
2.5 “Firmware Upgrade” button
Click this button to enter into the rmware upgrade window for ikeyboard Nano. Please refer
to P.15 for the rmware upgrade procedure.