User's Manual
Table Of Contents
- Introduction
- What's in the package?
- Register your ICON ProAudio product to your personal account
- Features
- Top Panel Layout
- Rear Panel Layout
- Getting Started
- Connecting Your QconPro X Controller
- Cubase
- Nuendo
- Logic Pro
- Samplitude
- Bitwig
- Reason
- Reaper
- Studio One
- Ableton Live
- Pro Tools
- Download the Mac iMap from your Personal
- User Page at www.iconproaudio.com
- Installing iMapTM Software for Windows
- Assigning DAW Mode (Mackie Control/HUI) or Defining MIDI Functions with iMapTM
- Assigning DAW Mode (Mackie control/HUI) Using iMapTM
- Assigning MIDI Messages in User-Defined Mode Using iMapTM
- Control Element Setup in User-Defined Mode
- Other Functions in iMap™
- Firmware upgrade
- Restore the factory default settings
- Specifications
- Services
- AppendixA
- Cubase
- Logic Pro X
- Pro Tools HUI
- Ableton Live 10
- AppendixB
- Cubase
- Logic Pro X
- Pro Tools HUI
- Ableton Live 10
- AppendixC
- Cubase
- Logic Pro X
- ProTools HUI
- Ableton Live 10
12
To change your Qcon Pro X DAW mode, turn off and on the power switch to
enter the DAW selection mode. Select your desired DAW from the list with
the “<<” / “>>” buttons.
(Tip: DAW button could not be activated if a DAW software is running.)
(Tip: Qcon Pro X will memorise your last selected DAW mode and re-enter the
same mode a few seconds after it has been switched on. (i.e. DAW mode
selection is not needed if the last mode is being used.)
(Note: If “Auto mode” is switched on, <</>> & DAW buttons will be ineffective.)
(Note: We will update Qcon ProX rmware from time to time to support
additional DAW apart from the current existing list. Please check our ofcial
website to download and upgrade your Qcon ProX rmware).
10. Sub-control buttons
This section on control buttons varies depending on which DAW is enabled. Please
refer to the text on the PVC overlay or the installed DAW aluminium panel. The
explanation below is based on Logic Pro.
10a) Assignment section
TRACK button - Activate the track parameters of the software.
PAN/EQ/Send/Plug-in/Instrument buttons - These buttons are used to
activate the corresponding effect function of the DAW. They are typically
used in conjunction with the rotary encoder knobs. Press the button, its light
will turn on, and then rotate the rotary encoder knob to adjust the value,
which will display on the LCD directly above.
10b) Automation section
GROUP - Press to enter “Group” edit mode.
READ/Off button - Press the READ button to activate the read function of
the current audio track.
WRITE button - Press the WRITE button to activate the write function of
the current audio track.
TOUCH button - Press to set selected track’s automation to Touch.
LATCH - Press to set selected track’s automation to Latch.
TRIM - Currently unassigned.
11. User-dened control buttons
This section of control buttons is user-dened in Mackie control mode (HUI mode).
You may set their parameters according to your personal needs. PVC labeling mask
is included for noting the set parameters.