User's Manual

37
 “Control elements chart”
Message
type
Channel Message
Pitch 1-9 0-127
CC Bank MSB to Poly Mode On
Touch sensitive Note - C(-1) to G(9)
Slide CC - 0-9
Touch sensitive CC - 0-100
Rotate CC - Bank MSB to Poly Mode On
Enter Note - C(-1) to G(9)
Rotate CC - 0-9
Enter CC - 0-100
MCP
All buttons except "Lock",
"<<",">>","DAW"button
Note - C(-1) to G(9)
MCP
HUI
MCP
HUI
ControlControl protocol
MCP
HUI
Rotate
Rotate CC
Avalaible MIDI message setting values
Element
-
-
0-9
0-9
CC - 0-100HUI
Faders
Knobs
JogWheel
Buttons
Slide
All buttons except "Read", "Write",
"Touch", "Latch","Trim", "Off","Plug-
in"
CC
Other Functions in iMap™
1. “Save le” button
 Click this button to save your current settings for the QconPro X. The le is an “.
QconPro X” le.
2. “Load le” button
 Click this button to load a previously saved “. QconPro X” setting le for your
QconPro X.
3. “Firmware Upgrade” button
 Click this button to enter into the rmware upgrade window for QconPro X.
Please refer to P.38 for the rmware upgrade procedure.
3
21