Operation Manual

22
5
MEMORY CHANNELS
New2001
5
Each memory channel can be programmed with an alpha-
numeric channel name for easy recognition, and can be dis-
played independently by channel. Names can be a maximum
of 6 characters.
q Push [V/M] to select the memory mode.
w
Rotate [DIAL] to select a desired memory channel.
e
Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “
” icon and memory channel number blink.
r While holding down [MODE], rotate [DIAL] to select the
“M NAME” or “B NAME” item when programming the
memory name or the bank name, respectively.
• The item can also be selected by pushing [MODE] repeatedly.
Bank name selectionMemory name selection
• After releasing [MODE], a line blinks under the first digit, and
the “
” icon blinks.
t While holding down [FUNC], rotate [DIAL] to select a
desired character.
• The selected character blinks.
y Rotate [DIAL] to move the cursor to the right or to the left.
Bank nameMemory name
u Repeat steps t and y until a desired 6-character chan-
nel name is displayed.
i
Hold down [S.MW](V/M) for 1 second to program the
name and exit the programming mode.
• 3 beeps sound.
• Available characters
A to Z, 0 to 9, ( , ) , *, +, –,
, , /, |, = and space.
NOTE: Only one bank name can be programmed into
each bank. Therefore, the previously programmed bank
name will be displayed when bank name is selected. Also,
the programmed bank name is automatically assigned to
another bank channel.
■ Programming memory/bank name