Manualshelf

Operation Manual

ManualsBrandsIcon ManualsAudioIC-R6
31323334353637383940
24
5
MEMORY CHANNELS
New2001
5
■
Copying memory contents
This function copies a memory channel’s contents to the VFO
(or another memory channel). This is useful when searching for
signals around a memory channel frequency and for recalling
the frequency offset, subaudible tone frequency etc.
D MemoryVFO
q Select the memory channel to be copied.
➥ Push [V/M] to select the memory mode, then rotate
[DIAL] to select a desired channel.
• If desired, push [BAND] repeatedly to select a desired bank
group, then rotate [DIAL] to select a desired bank channel.
w Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “
” icon and memory channel number blink.
e Rotate [DIAL] to select “VF.”
r
Hold down [S.MW](V/M) for 1 second to write the selected
channel contents into the VFO.
• The VFO mode is automatically selected.
Holding down [S.MW](V/M) for 2 seconds in step w will
also copy the memory contents to the VFO. In that case,
steps e and r are not necessary.
D Memorymemory
q Select the memory channel to be copied.
➥
Push
[V/M]
to select the memory mode, then rotate
[DIAL] to select a desired channel.
w Hold down [S.MW](V/M) for 1 second to enter the select
memory write mode.
• 1 short and 1 long beep sounds.
• The “
” icon and memory channel number blink.
• Do not hold down [S.MW](V/M) for more than 2 seconds.
Otherwise the memory contents will be copied to the VFO.
e Rotate [DIAL] to select the target memory channel.
r
Hold down [S.MW](V/M) for 1 second again to copy.