Operation Manual

33
6
SCAN OPERATION
New2001
■ Memory/all bank/bank link/bank scan
q Push [V/M] to select the memory mode.
w
Set the squelch level.
e Hold down [SCAN](MODE) for 1 second to enter the scan
type selection mode.
r
Rotate [DIAL] to select a desired scanning type.
• Select “M-ALL” for all memory scan, “B-ALL” for all bank scan,
“B-LINK” for bank link scan or “BANK-x” for bank scan (x= A to
R, T, U, W, Y; only programmed bank groups are displayed).
[DIAL]
• All memory scan
• All bank scan
• Bank link scan
• Bank scan
Selectable between
“A” to “R,” “T,” “U,” “W” or “Y,”
if programmed (p. 20)
See page 53 for details of the bank link
programming.
Rotate
Hold down
for 1 sec.
t To start the scan, push [SCAN](MODE).
• The scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
resumes scanning.
• Push [SCAN](MODE) again to stop the scan.
During memory/
all bank/bank link scan
During bank scan
IMPORTANT: To perform a memory or bank scan, two or
more memory/bank channels MUST be programmed,
otherwise the scan will not start.