Operation Manual

42
8
TONE SQUELCH AND POCKET BEEP
New2001
8
• Available tone frequencies (unit: Hz)
67.0
69.3
71.9
74.4
77.0
79.7
82.5
85.4
88.5
91.5
94.8
97.4
100.0
103.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8
136.5
141.3
146.2
151.4
156.7
159.8
162.2
165.5
167.9
171.3
173.8
177.3
179.9
183.5
186.2
189.9
192.8
196.6
199.5
203.5
206.5
210.7
218.1
225.7
229.1
233.6
241.8
250.3
254.1
NOTE: The receiver has 50 tone frequencies and conse-
quently their spacing is narrow compared to units having
38 tones. Therefore, some tone frequencies may receive
interference from adjacent tone frequencies.
• Available DTCS codes
023
025
026
031
032
036
043
047
051
053
125
131
132
134
143
145
152
155
156
162
245
246
251
252
255
261
263
265
266
271
356
364
365
371
411
412
413
423
431
432
506
516
523
526
532
546
565
606
612
624
054
065
071
072
073
074
114
115
116
122
165
172
174
205
212
223
225
226
243
244
274
306
311
315
325
331
332
343
346
351
445
446
452
454
455
462
464
465
466
503
627
631
632
654
662
664
703
712
723
731
732
734
743
754
D DTCS polarity setting
As well as the code setting, the polarity setting is also avail-
able for DTCS operation. When a different polarity is set, the
DTCS never releases the audio mute, even if a signal with
matched code number is received.
q
Hold down [SET](TS) for 1 second to enter the Set mode.
w
Rotate [DIAL] to select the “EXPAND” item.
e
While holding down [FUNC], rotate [DIAL] to turn the
Expand set mode ON.
r
Rotate [DIAL] to select the “DTCS P” item.
[DIAL]
After 1 sec.
t While holding down [FUNC], rotate [DIAL] to select either
normal (NORMAL) and reverse (REV) polarity.
Normal polarity Reverse polarity
y Push [SET](TS) to exit the Set mode.